N20 12V 120 RPM Micro Metal Gear Motor With Encoder

These N20 12V 120RPM Micro Metal Gear Motor With Encoder is intended for use at 12 V. Though in general, these kinds of motors can run at voltages above and below this nominal voltage; so they should comfortably operate in the 3-12 V range (rotation can start at voltages as low as 0.5V).

Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gear motors are available in a wide range of gear ratios from 5:1 up to 1000:1. With the exception of 1000:1 gear ratio versions, all of the micro metal gear motors have the same physical dimensions; so one version can be easily swapped for another if your design requirements change.

N20 Specification:

• Model No. : GA12 N20
• Rated Operating Voltage (VDC) : 12
• No Load Current (mA) : 10 mA
• Stall Current (A) : 1
• Rated Speed (RPM) : 110
• Rated Torque(kg-cm) : 1.20
• Stall Torque(Kg-Cm) : 9
• No load Speed (RPM) : 120
• Gear Ratio : 200 : 1
• Shaft Type : D-type , Single Side
• Shaft Diameter (mm) : 3
• Weight (gm) : 11
• Screw Size : M3

N20 Features:

• This is a DC Mini Metal Gear Motor, ideal for making robots
• Lightweight, high torque and low RPM.
• Fine craftsmanship, durable, not easy to wear.
• With excellent stall characteristics, one can climb hills easily.
• You can also easily mount a wheel on the motor’s output shaft.

Package Included:

• 1 x N20 12V 120RPM Micro Metal Gear Motor With Encoder.
• 1 x Connector(14 cm).