Waveshare 64×128, General 1.3inch OLED Display Module

1.3 inch OLED HAT, SPI/I2C interfaces

OLED Specification

• Working Voltage3.3V
• Communication Interface:/IIC
• ControllerSH1107
• Resolution64 × 128
• Display Area14.7 × 29.42 (mm)
• Pixel size0.15 × 0.15 (mm)
• Dimension: 30 × 39.5 (mm)
• Color: Black/White

OLED Pin

OLED Hardware Configuration :

The OLED module provides two drive interfaces: 4-wire SPI and I2C. There is a resistor that can be soldered on the back of the module, and the corresponding communication mode can be selected through the selection of the resistor, as shown in the figure:
The module uses 4-wire SPI communication mode by default, that is, IM is connected to 0 by default (1 and 0 do not represent the level, just the welding method of connecting or connecting the resistance, the specific hardware link is shown in the following table):
Note: The above picture is the welding on the hardware, the following table is the actual hardware connection

The specific hardware configuration is as follows:

• Using 4-wire SPI:

That is, the factory program setting: IM is connected to 0 and connected to the ground;

• Using I2C:

IM is connected to 1 to VCC (3.3V);
When using I2C: The high and low state of DC can control the address of the slave device. If it receives a low level, then the 7-bit address of I2C is: 0x3C;
PS: The program defaults to SPI mode. If you need to switch the mode, please modify DEV_Config.h. For details, please refer to the program description – bottom hardware interface – interface selection

OLED and its controller

This OLED integrates the SH1107 controller which has 128×128 bits SRAM, supports 128×128 resolution. The controller features SPI/IIC/ 6800/8080 interface and 256 brightness levels. The resolution of this 1.3inch OLED is only 64×128, only half of the SRAM is used.
This OLED use four-line SPI and I2C interface for communicating, which supports higher compatibility and speed.

Package Included :

1 X 1.3inch OLED Display Module