3DR Radio Wireless Telemetry Kit

Experience the power of wireless telemetry communication with the 3DR Radio Wireless Telemetry Kit. Designed for compatibility with APM2.6, APM2.7, APM2.8, Pixhawk, and PX4 flight controllers, this kit enables seamless data transmission and control between your ground station and drone. Let’s explore the remarkable features that make this kit an essential tool for drone enthusiasts and professionals.

With the 3DR Radio Wireless Telemetry Kit, you can establish a reliable and robust wireless communication link with your drone. The kit operates at the 915MHz frequency, ensuring strong and stable signal transmission over extended ranges. Stay connected to your drone, receive real-time telemetry data, and maintain full control even from a distance.

Setting up the 3DR Radio Wireless Telemetry Kit is quick and hassle-free. The kit includes a USB module that connects to your ground station device, providing a convenient interface for communication. Simply plug in the USB module, configure the settings, and establish a wireless connection with your drone. Enjoy the simplicity and ease of use with this plug-and-play solution.

The 3DR Radio Wireless Telemetry Kit is compatible with a range of flight controllers, including APM2.6, APM2.7, APM2.8, Pixhawk, and PX4. Whether you’re using a fixed-wing aircraft, multirotor, or any other drone platform, this kit ensures seamless integration and communication. Expand your possibilities and take full advantage of the telemetry capabilities of your flight controller.

The 3DR Radio telemetry system is designed as an open-source Xbee replacement radio set, offering a lower price, longer range and superior performance to Xbee radios.

3DR telemetry 915mhz set for multiwii setting. PLUG AND PLAY. Pre-configured and tested to 115200 BAUD rate, and all other settings needed

The 3DR Radio telemetry system is designed as an open-source Xbee replacement radio set, offering a lower price, longer range and superior performance to Xbee radios.

preprogram these radios to the correct body rate so you can just connect them to your quadrino and start changing PIDs on the fly.
It’s available in 915Mhz; and in the following configurations: serial board (for the air) and USB (for the ground).
The radio is a 2-way half-duplex wireless communication system with a standard TTL UART interface, based on HopeRF’s HM-TRP data link modules,
and custom firmware that improves upon the modules’ original features and performance.
– The SiK firmware includes a bootloader that permits radio firmware upgrades over the serial interface,

Specification

Frequency Channel: 915 MHz
Receiving Sensitivity: -117dBm
Transmitted Power: Up to 20dBm(100mW)
Antenna Connector: RP-SMA
Connector Output Power: 100mW(20dBm)
Air Data Rates: 250kbps
Operating Temperature: -10 to 85 °C
Sensitivity can be adjusted between 1-20dBm
Sensitivity Interface: Standard TTL UART

Features

Transparent serial link
Air data rates up to 250kbps
MAVLink protocol framing and status reporting
Frequency-hopping spread spectrum (FHSS)
Adaptive time-division multiplexing (TDM)
Support for LBT and AFA
Configurable duty cycle
Built-in error-correcting code (can correct up to 25% data bit errors)
Demonstrated range of several kilometres with a small Omni antenna
Can be used with a bi-directional amplifier for even more range
Open source firmware
AT commands for radio configuration
RT commands for remote radio configuration
Adaptive flow control when used with APM
Based on HM-TRP radio modules, with Si1000 8051 micro-controller and Si4432 radio module